Device Pairing

How do I ensure the MCU does not automatically enter the Smart Config state after power-on, and recognizes the unbinding state from the app to control the LED?

Wi-Fi device pair failure self-check process?

Wi-Fi general solution What protocol will the module reply after the MCU sends the reset pair command?

When is the pair self-processing mode provided by the Wi-Fi general solution protocol generally used?

MCU SDK development, how should the MCU determine the network configuration status of the Wi-Fi module?

I need to disconnect a module from the network from the module end. After sending a pairing or reset command to the module, the module clears existing pairing information. However, after a period of time, the module automatically connects to the original network. What can I do？

Wi-Fi pair mode selection to prevent accidental touch, if the device is unbound on the app, what state will the device return to?

How to turn off the pair mode of the WBR3 module?

How to solve the problem of WBR3 device failing to pair properly?

How to manually interrupt the pair after the WBR1 module enters pair mode? How to deal with poor Wi-Fi signal?