Cancel

What is the network access/reset logic of the Zigbee smart switch (no neutral wire required) SoC solution?

Last Updated on：2024-09-18 07:35:58

Button: Any one of the switches is reused as a network distribution button.

Indicator: The network indicator and the status indicator of the switch are multiplexed with the same light.

Networking process: The indicator flashes to indicate normal distribution network
Control: The indicator indicates that the load light is on

Distributed network: Need to be used with Tuya Zigbee gateway 1. The user long presses any button of the switch for 5S to enter the network configuration state. At this time, the indicator flashes quickly and the load light is on, indicating that it is pairing. And at this time, short press the switch, the load light can not be controlled. 2. Network configuration is successful: the indicator light stops flashing, and the local button can control the load normally. 3. Failed to configure the network: If the network has not been configured, the indicator will stop flashing after 30s. At this time, the local button can control the load switch normally.

Reset/delete device:

Method 1: The user long presses any button of the switch for 5 seconds, the local device is reset, and the App prompts that the device has been deleted. At this time, the indicator flashes quickly and the load light is on, indicating that it is pairing;

Method 2: App panel On the settings page, click "Delete Device", the APP deletes the device, and the local device enters the reset state: At this time, the two load lights are on at the same time, the network LED indicator flashes, and the other indicator is consistent with the load light, indicating that it is pairing in.

Off-grid: 1. When the switch can’t find the gateway and the off-grid state appears (the device will try to rejoin 3 times, the duration is 30s), the device enters a low-power standby state, and the App is uncontrollable at this time; 2. Wait for the next local time When the button triggers the control, the switch starts to search for the gateway. After the device is online again, the app can be controlled.